In order to use relatively high production efficiency to process the heat resistant super alloys (HRSA), must be fully and carefully prepare the corresponding machining strategy. Due to the turning operations dominate in the field of heat-resistant super alloys processing (at least more than 50% of the process is turning), so the correct application of the blade is one of the keys to ensure the success, its basic principles should be based on the use of appropriate cutting edge methods.
Heat-resistant super alloys (HRSA) has some unique properties, such as excellent high temperature strength, good toughness and corrosion resistance, making it be the sole material selection for the turbines, jet engines, chemical and food equipment, medical devices parts. However, these properties also means the cutting is very difficult - particularly those that require especially efficient processing. Due to HRSA has poor workability ,thus requiring all aspects of the entire process chain - from the machine to the CAD, from the shank to the cutting edge, must be good planning, selection and application.
When turning, the Cutting tool's cut-in having great influence. The turning cutting edge to the workpiece's cut-in depends primarily on the tool cutting edge angle of the cutting edge, especially when turning heat resistant super alloys, will directly affect the competitiveness of the production efficiency, because it will directly affect the tool's feed rate - the value largely determines the required cutting time. When the tool cutting edge angle is large, the feed rate is mainly limited by the blade allowable load, partly determined by the chip thickness. When the tool cutting edge angle is small, the chip thickness must be large enough to enable the cutting edge through the normal cutting instead squeeze rub the surface of the workpiece to form chips. In this connection, the cutting depth is constant, the longer the cutting edge, the formed chips will be thinner (in other words, the tool cutting edge angle is smaller,the chips will be thinner), this moment should use a higher feed rate in order to maintain a normal cutting.
Tel
E-mail
WhatsApp
Inquiry